WARNING: Wear ear protection.
Vibration
-
h,M
or less
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING: The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
to protect the operator that are based on an estima-
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
EC Declaration of Conformity
For European countries only
to this instruction manual.
SAFETY WARNINGS
Cordless vacuum cleaner safety
warnings
WARNING: IMPORTANT! READ CAREFULLY
all safety warnings and all instructions BEFORE
USE .
Before use, make sure that this cleaner must
be used by people who have been adequately
instructed on the use of this cleaner.
If foam/liquid comes out, switch off
immediately.
Clean the water level limiting device regularly
and examine it for signs of damage.
AVOID UNINTENTIONAL STARTING. Be sure
switch is OFF when installing battery(ies).
6.
metal chips, sharp materials such as razors,
needles, broken glass or the like.
7. NEVER USE THE CLEANER IN THE VICINITY
OF GASOLINE, GAS, PAINT, ADHESIVES OR
OTHER HIGHLY EXPLOSIVE SUBSTANCES.
8.
Never vacuum up toxic, carcinogenic, combusti-
ble or other hazardous materials such as asbes-
tos, arsenic, barium, beryllium, lead, pesticides,
or other health endangering materials.
9. Never use the cleaner outdoors in the rain.
Do not use close to heat sources (stoves, etc.).
Do not block cooling vents. These vents per-
mit cooling of the motor. Blockage should be
carefully avoided otherwise the motor will burn
out from lack of ventilation.
Keep proper footing and balance at all times.
Do not fold, tug or step on the hose.
Stop the cleaner immediately if you notice
poor performance or anything abnormal
during operation.
REMOVE THE BATTERY(IES). When not in
use, before servicing, and when changing
accessories.
Clean and service the cleaner immediately after
each use to keep it in tiptop operating condition.
MAINTAIN THE CLEANER WITH CARE. Keep
the cleaner clean for better and safer per-
formance. Follow instructions for changing
accessories. Keep handles dry, clean, and free
from oil and grease.
CHECK DAMAGED PARTS. Before further use
of the cleaner, a guard or other part that is
damaged should be carefully checked to deter-
mine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, break-
age of parts, mounting, and any other condi-
tions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere
in this instruction manual. Have defective
switches replaced by authorized service cen-
ter. Don’t use the cleaner if switch does not
turn it on and off.
REPLACEMENT PARTS. When servicing, use
only identical replacement parts.
STORE IDLE CLEANER. When not in use, the
cleaner should be stored indoors.
container shall be dried before storage.
Be kind to your cleaner. Rough handling can cause
breakage of even the most sturdily built cleaner.
To Next Page
Loading...
