Makita EB7660TH - User Manual

Other manuals for Makita EB7660TH

Instruction Manual20 pages

Questions and Answers

S
Steven KingJul 31, 2025
What to do if my Makita EB7660TH Blower engine stops soon or the engine speed does not increase?
- J
  james83Jul 31, 2025
  If your Makita Blower engine stops soon after starting, or if the engine speed doesn't increase, consider the following: * **Insufficient warm-up:** Ensure you perform the warm-up operation. * **Choke lever position:** If the engine is warmed up, make sure the choke lever is set to “OPEN.” * **Clogged fuel filter:** Clean the fuel filter. * **Contaminated or clogged air cleaner:** Clean the air filter. * **Detached control cable:** Attach the control cable securely.
M
Mark HenryAug 4, 2025
What to do if my Makita Blower engine does not stop?
- J
  Jose WeissAug 4, 2025
  If your Makita Blower engine does not stop, run the engine at idling speed and set the choke lever to the “CLOSE” position. Check for: * **Detached connector:** Attach the connector securely.
J
jennifer40Aug 9, 2025
What to do if Makita EB7660TH engine stops soon or speed doesn't increase?
- M
  Michael PetersAug 9, 2025
  If your Makita Blower engine stops soon after starting, or if the engine speed does not increase, it might be due to insufficient warm-up. Try performing a warm-up operation. Also, if the choke lever is set to “CLOSE” although the engine is warmed up, set it to “OPEN.” Another potential cause is a clogged fuel filter; in this case, clean the fuel filter.
G
gramirezAug 13, 2025
What to do if Makita Blower engine does not stop?
- A
  Audrey RyanAug 13, 2025
  If your Makita Blower engine does not stop, even when running at idling and setting the choke lever to “CLOSE”, it might be due to a detached connector. Attach the connector securely.
D
David WoodsAug 17, 2025
How to fix Makita EB7660TH throttle that does not return to idling speed?
- S
  Sheri WilliamsonAug 17, 2025
  If the throttle on your Makita Blower does not return to idling speed, it might be due to an improper throttle valve position. Reposition the control cable and adjust the throttle valve position by turning the cable adjusting bolt.
Z
zfieldsAug 21, 2025
How to fix a Makita EB7660TH throttle that won't return to idling speed?
- C
  Caitlin EstradaAug 22, 2025
  If the throttle on your Makita Blower does not return to idling speed, it could be due to an improper throttle valve position. To resolve this, reposition the control cable and adjust the throttle valve position by turning the cable adjusting bolt.
R
Ryan RoseOct 26, 2025
Why won't my Makita Blower engine start?
- S
  Scott MartinezOct 26, 2025
  There are several reasons why your Makita Blower engine might not be starting: * **Failure to operate primer pump:** Push the primer pump 7 to 10 times. * **Low pulling speed of starter rope:** Pull the starter rope strongly. * **Lack of fuel:** Refuel the blower. * **Clogged fuel filter:** Clean the fuel filter. * **Bent fuel tube:** Straighten the fuel tube. * **Deteriorated fuel:** Replace the old fuel with new fuel (recommended replacement every 1 month). * **Excessive suction of fuel:** Set the throttle lever from medium to high speed and pull the starter handle until the engine starts. If it still won't start, remove the spark plug, dry the electrode, reassemble, and try starting again. * **Detached plug cap:** Attach the plug cap securely. * **Contaminated spark p...

Summary

SPECIFICATIONS

IMPORTANT SAFETY INSTRUCTIONS

General instructions

General guidelines for safe and correct operation of the blower.

Personal protective equipment

Recommended protective equipment for safe operation.

Starting up the blower

Transport

Refuelling

Procedures and safety precautions for refuelling the blower.

Maintenance instructions

ASSEMBLY

BEFORE STARTING THE ENGINE

Checking and refill of engine oil

Fuel supply

Instructions and warnings for safely supplying fuel to the engine.

OPERATION

Starting the engine

Detailed steps for starting the engine, including cold and warm starts.

Blower Operation

Transporting the blower

MAINTENANCE

Replacing engine oil

Cleaning of air cleaner

Checking the spark plug

Cleaning the fuel filter

Fault location

Interval of inspection and maintenance

TROUBLE SHOOTING

State of abnormality

Makita EB7660TH Specifications

General

Power	- W
Airspeed	331.2 km/h
Noise level	102.8 dB
Suction mode	-
Product color	Black, Blue
Suction capacity	1200 m³/h
Working technology	Four-stroke petrol
Battery voltage	- V
Quantity per pack	1 pc(s)