S
Shawn MooreAug 8, 2025
Why doesn't the cutting disc start turning on my Makita EK8100?
- TTaylor SpencerAug 8, 2025
A damaged clutch can cause the cutting disc of your Makita Cutter not to start turning.
To Next PageTo Next PageWhy doesn't the cutting disc start turning on my Makita EK8100?
A damaged clutch can cause the cutting disc of your Makita Cutter not to start turning.
Why won't my Makita Cutter engine start?
Several issues can cause your Makita Cutter's engine to fail to start or start with difficulty. These include malfunctions in the fuel supply or compression systems, mechanical issues, the STOP switch being on, wiring faults or short circuits, a defective plug cap or spark plug, incorrect choke position, a defective carburetor, a dirty suction head, a bent or interrupted fuel line, a defective cylinder base packing ring or radial shaft packings, defective cylinder or piston rings, a spark plug that doesn't seal, a broken starter spring, or broken parts inside the engine.
Why does my Makita EK8100 Cutter have insufficient power?
If your Makita Cutter has insufficient power, it could be due to a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen.
Why is my Makita Cutter difficult to start when warm?
If you are experiencing warm start difficulties with your Makita Cutter, it may be due to wrong carburetor adjustment.
Why is the cutting disc running in idle on my Makita EK8100 Cutter?
If the cutting disc of your Makita Cutter runs in idle, it could be due to an incorrect idle speed, a blocked clutch, insufficient belt tension, or a worn V-belt.
General
