Makita TD110D User Manual

7 ENGLISH
Disposing of dust for high
performance lter
Inordertodropduststickingonthelterinthecapsule,
tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
2
1
►1. Capsule 2. Suction inlet
NOTE: Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
Remove accumulated dust from inside of capsule and
offofhighperformancelter.
1
2
►1. Capsule 2.Highperformancelter
Twisthighperformancelterindirectionofarrowtounfas-
tensecuringlipfromcleanerunitandthenpulloffthelter.
1
►1. Securing lip
Cleanoutthenedustandlightlytaptodislodgedust
fromhighperformancelter.
Reassembly
Reassembly for normal lter
Putonthelterfullyinpositiononthecleanerunit.
1
►1. Filter
NOTICE: Make sure the lter is put on straight
without being peeled back.Ifthelterisputon
incorrectly as illustrated, dust will get into the motor
housing, and cause a motor failure.
1
►1. Filter
Installtheprelter.Atthistime,makesuretotwistthe
preltersothatthesecuringlipisrmlylockedinthe
cleaner unit.
2
1
►1.Prelter2. Securing lip

Makita TD110D Specifications

General

Voltage	10.8V
Max Torque	110 Nm
No Load Speed	0-2, 600 RPM
Impacts Per Minute	0 - 3, 200 ipm
Battery Type	Li-ion
Driving Shank	1/4" Hex
Machine Screw	M4-M8
Standard Bolt	M5-M12
High Strength Bolt	M5-M10
Coarse thread screw (length)	22-90 mm
Weight with battery	1.2 kg
Length	153 mm
Blows Per Minute	0 - 3, 200 ipm