Makita TD110D User Manual

8 ENGLISH
Install the capsule. Align the mark on the capsule with
themarknearthehandleandthenrmlytwistthecap-
sule in direction of the arrow until it is secured.
1
►1. Mark
1
2
3
►1. Capsule 2. Handle 3. Mark
NOTE: Always remove dust ahead of time, as the
suction power will be reduced if there is too much
dust in the cleaner.
NOTICE: Always be sure to check that both the
lter and prelter are loaded correctly prior to
using the cleaner. If they are not loaded correctly,
dust will get into the motor housing, and cause a
motorfailure.Ifthefollowingexamplesoccur,thelter
andprelterarenotloadedcorrectly.Reloadthem
correctly to rectify problem.
Problem Examples
Example1:Onlytheprelterhasbeenloaded(nolter)
1
►1.Prelter
Example2:Onlythelterhasbeenloaded(noprelter)
1
►1. Filter
Example3:Thelterhasbeenloadedinapeeledback
state
1
►1. Filter

Makita TD110D Specifications

General

Voltage	10.8V
Max Torque	110 Nm
No Load Speed	0-2, 600 RPM
Impacts Per Minute	0 - 3, 200 ipm
Battery Type	Li-ion
Driving Shank	1/4" Hex
Machine Screw	M4-M8
Standard Bolt	M5-M12
High Strength Bolt	M5-M10
Coarse thread screw (length)	22-90 mm
Weight with battery	1.2 kg
Length	153 mm
Blows Per Minute	0 - 3, 200 ipm