Makita TD110D User Manual

9 ENGLISH
Example4:Thesecuringlipontheprelterisnotrmly
locked in the groove of cleaner housing
1
2
3
►1. Securing lip 2.Prelter3. Groove of cleaner
housing
Reassembly for high performance
lter
Connecthighperformancelter.Atthistime,makesure
totwisthighperformanceltersothatsecuringlipis
rmlylockedintocleanerunit.
21
►1.Highperformancelter2. Securing lip
1
►1. Securing lip
Install the capsule. Align the mark on the capsule with
themarknearthehandleandthenrmlytwistthecap-
sule in direction of the arrow until it is secured.
1
►1. Mark
1
2
3
►1. Capsule 2. Handle 3. Mark
NOTE: Always remove dust ahead of time, as suction
power will be reduced if there is too much dust in
cleaner.
NOTE: Always be sure to check that high perfor-
mancelterisloadedcorrectlypriortousingcleaner.
If they are not loaded correctly, dust will get into the
motor housing, and cause motor failure.
If the following examples occur, high performance
lterisnotloadedcorrectly.Reloadthemcorrectlyto
rectify problem.
Problem Examples
Securinglipofhighperformancelterisnotrmly
locked into groove of cleaner housing.
12
►1. Securing lip 2. Groove of cleaner housing

Makita TD110D Specifications

General

Voltage	10.8V
Max Torque	110 Nm
No Load Speed	0-2, 600 RPM
Impacts Per Minute	0 - 3, 200 ipm
Battery Type	Li-ion
Driving Shank	1/4" Hex
Machine Screw	M4-M8
Standard Bolt	M5-M12
High Strength Bolt	M5-M10
Coarse thread screw (length)	22-90 mm
Weight with battery	1.2 kg
Length	153 mm
Blows Per Minute	0 - 3, 200 ipm