Why does my Makita UR006G Trimmer motor stop running after a little use?
If your Makita Trimmer motor stops running after a short period, it could be due to a low battery charge level. Recharge the battery cartridge, and if that's not effective, replace it. Another possible cause is overheating. Stop using the tool to allow it to cool down.
What to do if the cutting tool does not rotate on my Makita UR006G?
If the cutting tool of your Makita Trimmer does not rotate, and you've stopped the machine immediately, it could be due to a foreign object, like a branch, jammed between the guard and the cutting tool. In this case, remove the foreign object. Alternatively, the cutting tool might be loosely attached; ensure it is securely tightened.
Why is my Makita UR006G motor not running?
If your Makita Trimmer motor isn't running, ensure the battery cartridge is properly installed. If the battery is the problem (under voltage), recharge it. If recharging doesn't work, replace the battery cartridge.
Why does my Makita Trimmer motor not run?
If the motor of your Makita Trimmer does not run, first ensure that the battery cartridge is properly installed. If it still doesn't run, the battery might be the problem (under voltage). Try recharging the battery cartridge, and if that doesn't work, replace it.
How to fix a Makita Trimmer that does not reach maximum RPM?
If your Makita Trimmer isn't reaching its maximum RPM, first ensure the battery cartridge is correctly installed. If the problem persists, try recharging the battery cartridge, or replace it if necessary.
Why won't my Makita UR006G Trimmer motor run?
If the motor of your Makita Trimmer isn't running, make sure the battery cartridge is correctly installed. If it is, the battery might be low; try recharging it.
What to do if my Makita Trimmer is vibrating abnormally?
If your Makita Trimmer is vibrating abnormally, replace the cutting tool. Also, make sure that you tighten the cutting tool securely. If the problem continues, further assistance may be needed.
What to do if my Makita UR006G has abnormal vibration?
If your Makita Trimmer is vibrating abnormally and you've stopped the machine immediately, it could be due to a broken, bent, or worn cutting tool. Replace the cutting tool. Another cause could be that the cutting tool is loosely attached, so tighten it securely.
What to do if Makita Trimmer cutting tool and motor cannot stop?
If the cutting tool and motor on your Makita Trimmer cannot be stopped, remove the battery immediately! This likely indicates an electric or electronic malfunction. Remove the battery cartridge and seek assistance from your local authorized service center for repair.
What to do if Makita UR006G has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, stop the machine immediately! This could be due to a broken, bent, or worn cutting tool, which requires replacement. It could also be that the cutting tool is loosely attached, so tighten it securely. If neither of these solutions works, the drive system may not be functioning correctly, and you should seek assistance from your local authorized service center.
General| Motor Type | Brushless |
|---|---|
| Power Source | Battery |
| Shaft type | Straight |
| Type | String Trimmer |
| Line Diameter | 1.4 mm |
| No Load Speed (RPM) | 7000 RPM |
| Spindle Size | M10 x 1.25 |
To Next Page
