Why does the motor stop running quickly on my Makita XCU05?
If the motor of your Makita Chainsaw stops running after a short time, the battery charge level may be low. Try recharging the battery cartridges. If the issue persists after recharging, consider replacing the battery cartridge.
How to fix a Makita XCU05 that does not reach maximum RPM?
If your Makita Chainsaw isn't reaching maximum RPM, make sure the battery cartridge is installed correctly. If it is, the battery power might be dropping, so recharge or replace the battery cartridge. If these steps don't resolve the issue, it could be a problem with the drive system.
What to do if the saw chain does not run on my Makita XCU05?
If the saw chain on your Makita Chainsaw isn't running, the chain brake might be activated. Try releasing the chain brake.
How to troubleshoot abnormal vibration in Makita XCU05 Chainsaw?
If you notice abnormal vibration in your Makita Chainsaw, it could be due to a loose guide bar or saw chain. In this case, adjust the guide bar and saw chain tension.
General| Type | Cordless Chainsaw |
|---|---|
| Power Source | Battery |
| Voltage | 18V |
| Bar Length | 12 inches |
| Motor | Brushless |
| Automatic Oiler | Yes |
| Battery Compatibility | Makita 18V LXT Lithium-Ion |
| Chain Gauge | 0.043 inches |
| Chain Pitch | 3/8 inches |
To Next Page
