Makita XWT09 User Manual

7 ENGLISH
Reversing switch action
AB
1
► 1. Reversing switch lever
CAUTION: Always check the direction of
rotation before operation.
CAUTION: Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION: When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Changing the impact force
1
2
3
4
5
► 1. Changed in three steps 2. Hard 3. Medium 4. Soft
5. Button
You can change the impact in three steps: hard, medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
is pressed, the number of blows changes in three steps.
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Specications of each impact force grade
Impact force grade displayed on
panel
Maximum blows Application
XWT07 /
XWT07XV
XWT08 /
XWT08XV
XWT09 /
XWT09XV
Hard
2,200 min
-1
(/min) Tightening when force and speed are desired.
Medium
2,000 min
-1
(/min) Tightening when you need good controlled power.
Soft
1,800 min
-1
(/min) Tightening when you need ne adjustment with
small diameter bolt.

Makita XWT09 Specifications

General

Brand	Makita
Model	XWT09
Category	Power Tool
Language	English