Page 4 of 13
If the regulator’s control operation is switched off, a dot is displayed on the regulator's
display (factory settings). By changing the parameter d1 (see 6. PROGRAMMING) from
the value 0 for value 1, when the regulator is switched off, the display will show the
current measured temperature.
4. SCHEME OF CONNECTION OF THE REGULATOR.
In order to connect the regulator to the device with which it is to be controlled,
the following should be done:
✓ prepare the hole in the refrigeration device to install the regulator
✓ place the regulator in the prepared hole and screw it in properly,
✓ place the temperature sensor inside the cooling chamber in the most convenient
place for temperature measurement and at the same time shielded from accidental
damage,
✓ connect the regulator to the outputs located on the rear wall of the casing, according
to the following scheme:
To Next Page
Loading...
