SM891
3
Place the machine near to the connection points and ensure that it is
level.
To do this, adjust the feet by screwing or unscrewing them as required.
When the machine is level, tighten the lock nuts on the feet using a
spanner.
Allow a good quantity of water to flow out of the
system until it is clear and free of impurities,
especially if the plant is new or has not been used
for some time. Two separate hoses to two faucets;
one hot and one cold.
Connect the hose from the hot water tap to the valve
with red filter and the hose from the cold water tap
to the other valve. Check that the other end of the
pipe is tightened properly.
DRAIN REQUIREMENTS
Position the drain hose between a minimum of 60
cm and a maximum 90 cm from floor level.
N.B. To prevent siphoning, do not make the machine
drain hose connection air tight.
If the water system is not provided with a drain, use
the bracket supplied to position the drain pipe over
a washbasin then tie it to a tap.
Check that the power supply and socket are correctly sized for the maximum
load demand of your machine. The power supply voltage is indicated on the
rating plate inside the door of the washing machine.
The domestic power supply must be equipped with an earth. If this requirement
is not complied with, the manufacturer will not be held responsible for any
damage or injury caused.
SETTING-UP THE MACHINE
ELECTRICAL CONNECTION
WATER CONNECTION
FIG. 4A
MIN. 60 CM
MAX.90 CM
A
To Next Page
Loading...
