Need help?Do you have a question about the Malmbergs PSD008 and is the answer not in the manual?
Instructions to read the manual carefully before using the appliance and keep for future reference.
Explains flammable gas risk during charging and need for ventilation.
Specifies suitability for lead acid, sealed, leisure, or gel batteries.
Covers storing the charger and user repair limitations.
Details risks like electrolyte, frozen batteries, short circuits, and cord handling.
Step-by-step guide for connecting the charger to the battery.
Microprocessor controls 9 stages for optimal battery charging and longevity.
Checks battery voltage and connections before charging begins.
Removes sulfate from lead plates to restore battery capacity.
Initial test for severely discharged batteries with reduced current.
Major charging phase, delivering most charge up to 75-80%.
Completes charge to nearly 100% at constant voltage.
Uses higher voltage to recondition battery sulfate for extended life.
Tests if the battery can hold its charge.
Maintains full charge with low voltage and minimal current.
Maintains 95-100% capacity by pulsing voltage when needed.
Provides 13.8V constant voltage and up to 5A for modern car systems.
Adjusts charging voltage automatically between 20°C to +45°C.
Compensates for voltage drop in cables for efficient charging.
Prevents damage if battery leads are connected incorrectly.
Prevents charging if clips touch while power is on.
Restarts charging from previous status after power interruption.
Includes anti-spark, overheating protection, warning buzz, and IP65 rating.
Explains Power LED (green) and Fail LED (red) functions.
Details indicators for battery level, charging modes, and stages on the LCD.
Slow charging for Standard or GEL lead acid batteries.
Fast charging for Standard or GEL lead acid batteries.
Fast charging for AGM type lead acid batteries.
Reconditions batteries degraded by long use or deep discharge.
Provides constant 13.8V/5A for car systems during battery changes.
Instructions for checking battery liquid levels and cell caps.
Procedure for connecting leads to battery and power outlet.
Steps for connecting, selecting mode, and starting the charging automatically.
Identifies issues like high voltage, soft start failures, and improper connections.
Describes when the battery is fully charged and ready for disconnection.
Post-charging actions like topping up fluid and replacing caps.
Advice on regular charging, terminal cleaning, and electrolyte levels.
Method for checking individual battery cells using a hydrometer.
Details operating voltage, current, stages, battery types, and protection class.
General| Brand | Malmbergs |
|---|---|
| Model | PSD008 |
| Category | Battery Charger |
| Language | English |
To Next Page
