Malossi CDI - Electrical Connections and Safety; Lambda Emulator Connection; Ignition Coil Installation Note

13
ITALIANOENGLISHFRANÇAISDEUTSCH
WARNING - Art. 
When itting this coil on
• APRILIA SPORTCITY CUBE
 ie T LC euro LEADER
MLM
• DERBI RAMBLA i  ie T LC
euro PIAGGIO
it is necessary to reverse the
wires of the original female
wiring connector which is
connected to the injector Fig. .
NB: in case Malossi coil is
removed, IT ISN’T needed to
restore the wires as in origin.
Force Master  lambda
emulator connection
The female connector
of the original
wiring - once disconnected from
the injector - must be connected
to the male connector of the
lambda emulator. After that the
female connector of the lambda
emulator must be connected
to the male connector of the
Force Master. In the end the
female connector of the Force
Master must be connected to the
injector.
We hope you found the above
instructions suiciently clear.
However, if any points are not
particularly clear, please contact
us completing the special
form inserted in the “contact”
section on our Internet site
malossistore.com. We thank
you in advance for any comments
and suggestions you may wish to
send us. So goodbye from us all
at Malossi, and please accept our
compliments. Have Fun. GOOD
LUCK and … see you next time.
The descriptions in this
publication are not binding.
Malossi reserves the right to make
modiications, if it considers
them necessary, and does not
accept any responsibility for any
typographic or printing errors.
This publication replaces all
previous publications referring to