Need help?Do you have a question about the Malossi FORCE MASTER 2.1 and is the answer not in the manual?
Instructions for control unit set-up and CDI assembly.
Details on connecting control unit cables to relevant connectors.
Steps for cutting and connecting injector wires with specific fastons.
How to connect the negative pole cable to the screw.
Steps for connecting the TPS using cable clamps and fastons.
Details on connecting the Coil using fastons.
Explains the control unit display and its status indicators.
Introduces the 'M', '-', and '+' buttons and their general purpose.
Describes the initial power supply activation and 'prime' phase.
Procedure for setting the throttle to idle and performing MIN calibration.
Steps for adjusting the MAX value by setting the gas knob to maximum.
How to select different pre-set maps using the control buttons.
Explains 'Low' and 'Mid' modes for RPM-based injection adjustment.
Describes the 'High' mode for injection adjustment at high RPM.
Details on selecting different maps using buttons and display indicators.
Explains 'Thr' for throttle opening and 'Diag' for diagnostics.
Describes the 'Info' mode for displaying ECU mapping and software version.
Covers 'KO MAP', 'TUNING TPS', 'INJ1 S.C.', and 'INJ1 O.C.' errors.
Explains 'IGN LOST', 'TPS N.C.', and 'TPS KWP2000' error messages.
Explains 'VBATT LOW' and 'VBATT HIGH' battery voltage errors.
Describes the display of selected map, settings, RPM, and THR status.
Lists carburation adjustment, RPM limiter, temperature, voltage, and consumption.
Describes the single base fuel curve (curve O) configuration.
Directs users to the website for warranty terms and contact information.
General| Lambda sensor simulation | Yes |
|---|---|
| Fuel adjustment | Yes |
| Product Type | ECU |
| Compatibility | Specific scooter models (check manufacturer's list) |
| Included Components | Wiring harness, Installation instructions |
To Next Page
