Malossi FORCE MASTER 2.1 - Battery Voltage Errors; Normal Operation and Technical Details; Normal Operation Display

31
ITALIANOENGLISH
31
ITALIANOENGLISH
• “VBATT LOW” - Battery voltage
too low
The battery voltage has been below
11V for at least 10 seconds.
The control unit is behaving
normally but problems may arise in
the general operation.
The operator must make
appropriate checks on the system
because this problem cannot be
caused by the control unit.
• “VBATT HIGH” - Battery voltage
too high
The battery voltage has been above
15.5V for at least 5 seconds.
The control unit is behaving
normally but problems may arise in
the general operation.
The operator must make
appropriate checks on the system
because this problem cannot be
caused by the control unit.
Normal operation
When switched on, the control unit
display shows the status of
• Selected map
• Low/mid/high setting
After this, the RPM and THR status
bars remain active.