24
ITALIANOENGLISH
24
ITALIANOENGLISH
MAX adjustment
NB: You will need the help of a friend
to adjust the MAX.
• Set the gas knob to maximum
• Press and hold the button (+)
throughout the calibration
sequence
• Turn the key to ON
• The display shows the maximum
calibration logo lashing
• If calibration successful, “OK”
appears
• If calibration was unsuccessful, the
message “OUT OF RANGE” appears
and it is necessary to repeat the
operation, checking that the
throttle is at idle
MAP selection
• Press and hold button M throughout
the calibration sequence
• Turn the key ON : the display will
show the selected map
• To change the map, turn the key
OFF-ON (keeping the M button
pressed), until the desired map is
selected
NB: the control unit will only display
the pre-set maps
The vehicle can now be switched on
and used.
To Next Page
Loading...
