Malossi FORCE MASTER 2.1 - Working Modes: RPM; Low and Mid RPM Modes

25
ITALIANOENGLISH
25
ITALIANOENGLISH
Working (Fig. 11)
These adjustments can be carried
out with the engine running, in
ventilated places.
Each time the ‘M’ button is pressed,
the display shows an indication
of the function being activated,
together with the switching on of a
dedicated LED on the edge of the
display.
In selection sequence, the
modes are:
1. “Low”: : shows the active
correction at low RPM (< 3000
RPM). If the engine is on, after
a few seconds of inactivity
it returns to the engine
screen display.
The “-” and “+” buttons reduce or
increase the injection correction
in 2% steps in the relevant RPM
ranges. When these buttons are
pressed, the selected correction
lashes. To conirm the selected
correction, it is necessary to wait
for the end of the lashing.
2. “Mid”: shows the active
correction at medium RPM
(between 3000 and 6000 RPM).
If the engine is on, after a few
seconds of inactivity it returns to
the engine screen display.