Malossi FORCE MASTER 2.1 - Working Modes: Maps & Throttle; High RPM Mode; Map Selection Mode

26
ITALIANOENGLISH
26
ITALIANOENGLISH
The “-” and “+” buttons reduce or
increase the injection correction
in 2% steps in the relevant RPM
ranges. When these buttons are
pressed, the selected correction
lashes. To conirm the selected
correction, it is necessary to wait
for the end of the lashing.
3. “High”: shows the active
correction at high RPM (> 6000
RPM). If the engine is switched
on, after a few seconds of
inactivity it returns to the engine
screen display.
The “-” and “+” buttons reduce or
increase the injection correction
in 2% steps in the relevant speed
range. When these buttons are
pressed, the selected correction
lashes. To conirm the selected
correction, it is necessary to wait
for the end of the lashing.
4. “Maps”: the active map is
displayed with the word “M”
followed by the map number and
a dierent map can be selected
using the “-” and “+” buttons. If
the engine is switched o, the
active map is always displayed. If
the engine is switched on, after
a few seconds of inactivity the
engine screen display returns.
Pressing the “-” and “+” buttons
shows the active map number on