EasyManua.ls Logo

Malossi FORCE MASTER 2.1 - First Power-Up; Power-Up Procedure; TPS Calibration; MIN Adjustment

Malossi FORCE MASTER 2.1
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
ITALIANOENGLISH
23
ITALIANOENGLISH
to increase or decrease the value
selected in the dierent functions
First power-up
Attention: when the key is turned
to start the vehicle, but the engine
is not started yet, the electronics
activates the power supply to all
actuators for a deined time of
approx. 3 seconds (“prime” phase).
The map and TPS calibration is
carried out starting with the vehicle
switched o.
TPS calibration
MIN adjustment
• Set the throttle knob to idle
• Press and hold the button (-) for the
entire calibration sequence
• Turn the key to ON
• The display shows lashing min
calibration logo
• If calibration successful, “OK”
appears
• If calibration was unsuccessful, the
message “OUT OF RANGE” appears
and it is necessary to repeat the
operation, checking that the
throttle is at idle

Other manuals for Malossi FORCE MASTER 2.1

Related product manuals