27
ITALIANOENGLISH
27
ITALIANOENGLISH
the right-hand side of the display,
while showing the map about to
be activated in lashing mode on
the left. To activate the map, wait
for the end of the lashing and
the letter “M” on the left followed
by the map number that has
been activated on the right.
5. “Thr”: shows “T %” for a few
seconds, then the TPS opening
percentage is displayed. By
moving the throttle all the way,
the percentage displayed should
range from 0% to 100%. If the
stroke does not go from 0 to
100, TPS calibration must be
performed. The TPS value always
remains displayed regardless of
the engine state.
6. “Diag”: shows the letter “D” for
a few seconds, then the active
errors if present, otherwise it
shows “NO ERROR”. If the engine
is switched on, after displaying
the complete sequence of all
information, it returns the engine
screen display returns, otherwise
this information continues to run
on the display.
7. “Info”: displays the letter “I” for
a few seconds, then the ECU
mapping name and software
version are shown. If the engine
is running, after displaying both
To Next Page
Loading...
