EasyManua.ls Logo

Mammoth J036HHC - Installation; Definition; Unit Placement-Horizontal; Unit Placement-Vertical

Default Icon
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation
Definition
DefinitionDefinition
Definition
Single refrigeration circuit, one unit section with fan outlet.
Unit
UnitUnit
Unit
Placement
PlacementPlacement
Placement-
--
-Horizontal
HorizontalHorizontal
Horizontal
See Figures 1 and 2
Mammoth’s heat pumps must be hung from the ceiling as
shown in Figure 1. Mounting brackets, rubber grommets,
bolts and washers are in place on the unit. The mounting
brackets are designed to accept up to 3/8-inch threaded
rods. A flat washer and two nuts (not supplied by
Mammoth) should be used to mount the unit on the ceiling-
attached threaded rods. When installed, the heat pump
should be slightly pitched toward the condensate drain
connection.
Unit
UnitUnit
Unit
Placement
PlacementPlacement
Placement-
--
-V
VV
V
ertical
erticalertical
ertical
See Figure 3
Mammoth’s heat pumps must be installed on a level
surface. We recommend placing a carpet pad or other
isolating material under the unit to prevent noise from
transmitting to the building structure. If the unit is installed
in a closet adjacent to the conditioned space, provide an
insulated return air duct with at least one 90-degree bend.
If a free return air system is used, position the filter-side of
the unit as close as possible to the return air grille.
Note: The unit is shipped from the factory with access to
the electrical box such that return air enters the unit from
the right side when facing the electric control box.
Model
ModelModel
Model
Number
NumberNumber
Number
Nome
NomeNome
Nomenclature
nclaturenclature
nclature
J
JJ
J
036
036036
036
H
HH
H
H
HH
H
C
CC
C
V
VV
V
oltage
oltageoltage
oltage
Unit
UnitUnit
Unit
Model number
Model number Model number
Model number
Unit
UnitUnit
Unit
T
TT
T
ype
ypeype
ype
T
TT
T
emperature
emperatureemperature
emperature
Range
RangeRange
Range
Design
DesignDesign
Design
Series
SeriesSeries
Series
D = 208-230/60/1
E = 265/60/1
F = 208-230/60/3
G = 460/60/3
J = 380/50/3
K = 575/60/3
L = 220/50/1
H =
Horizontal
Unit
V =
Vertical
Unit
H = Standard Range
L = Low Temp er atur e
Mammoth concerned about the product quality
and committed to a policy of continuous product
improvements ,Please based on the rating label
and the unit electrical wiring label, and thus
reserves the right to change specifications and
design without notice.