General Safety Instructions
22
Carefully read these Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
2.10 Signs
WARNING
Risk of injury due to illegible symbols
Labels and symbols get dirty over time, rendering them illegible.
For this reason:
S Always keep the safety, warning and operational signs in good legible condition.
S Clean or replace illegible safety, warning and operational signs.
The following symbols should be installed in the immediate vicinity of the hazard area.
Access forbidden
Areas displaying this sign must not be entered.
Electric Voltage
Spaces marked with this symbol may only be accessed by qualified electricians.
Unauthorised persons may not enter these spaces.
Hot Surfaces
Hot surfaces such as hot engines and hot fluids may not always be recognisable. Do not
touch these surfaces without protective gloves.
Danger to life due to suspended loads
During lifting operations, loads can swing out and fall down. This can cause serious in
jury and even death.
Risk of injury
Failure to follow the instructions poses a risk of injury.
To Next Page
Loading...
Need help?
General
