EasyManuals Logo

Man E3262 LE202 User Manual

Man E3262 LE202
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
Faults
83
Carefully read these Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
Fault Possible cause Remedy
Engine does not start
or starts poorly in cold
condition
D Spark plug faulty
D Ignition cable faulty
D Ignition coil faulty
D Ignition timing incorrectly set
D Starter turns slowly
D Check quality of gas
D Remedy from manufacturer ser
vice
D Battery with insufficient charge
or damaged
D Voltage drop between battery
and starter too high
Rough idling with en
gine warm,
misfiring
D Spark plug faulty
D Ignition cable faulty
D Ignition coil faulty
D Ignition timing incorrectly set
D Valve clearance not OK
D Zero pressure regulator of gas supply
not correctly set or faulty
D Insufficient compression in cylinder or
more than 3-4 bar pressure difference
between the cylinders
D Remedy from manufacturer ser
vice
Engine speed fluctua
tions during operation
D Spark plug faulty
D Ignition cable faulty
D Ignition coil faulty
D Ignition timing incorrectly set
D Shutoff solenoid valve of gas supply
closed/does not open
D Tachometer faulty
D Gas pressure regulator faulty
D Oxygen sensor faulty
D Remedy from manufacturer ser
vice
Poor performance D Spark plug faulty
D Ignition cable faulty
D Ignition coil faulty
D Ignition timing incorrectly set
D Throttle valve not in full throttle position,
actuation linkage sticks,
throttle valve incorrectly adjusted
D Zero pressure regulator of gas supply
not correctly set or faulty
D Gas metering valve faulty
D Gas/air mixture too rich or too lean
D More power than the engine can pro
duce is demanded
D Gas quality does not meet the regu
lations
D Cross section of oxygen regulation
valve is not set to the current gas
quality
D Oil level in oil pan too high
D See "Fuels, Lubricants and Coo
lants..."
D Remedy from manufacturer ser
vice
D Check whether the guide tube is
correctly installed and the cor
rect oil dipstick is being used
D If coolant is discovered in the
engine oil, check cylinder head
gasket, cylinder liner gasket and
piston rings

Table of Contents

Other manuals for Man E3262 LE202

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Man E3262 LE202 and is the answer not in the manual?

Man E3262 LE202 Specifications

General IconGeneral
BrandMan
ModelE3262 LE202
CategoryEngine
LanguageEnglish

Related product manuals