Manamed PlasmaFlow - Cleaning and Disinfecting; Battery and Charging Safety

6
Cleaning and Disinfecting
Note: Inspect the device and follow the cleaning and disinfecting procedures prior to use.
Warning: Device must be turned off and disconnected from the wall outlet prior to and during cleaning or disinfecting.
DO NOT IMMERSE DEVICE IN ANY LIQUID. DO NOT PLACE DEVICE IN AUTOCLAVE.
Clean the outer surface of the pump unit using a soft cloth, moistened with soapy water or 70% isopropyl alcohol. Air dry
only. Clean the exterior of the cuffs using a soft cloth, moistened with soapy water or 70% isopropyl alcohol. Air dry only.
Unit must be completely dry prior to use. To ensure unit is completely dry, leave the device in the OFF position and disconnected
from the wall outlet for at least 30 minutes (and as long as necessary for the unit to dry completely) after cleaning or disinfecting.
 s$ONOTREMOVETHEPUMPUNITFROMTHECUFF
 s$ONOTPLACECUFFSINTHEDRYERORMICROWAVE
 s$ONOTUSEAHAIRDRYERTOACCELERATEDRYING
 s$ONOTPLACETHEDEVICEONTOPOFORINFRONTOFPORTABLEORSTATIONARYRADIATORSTOACCELERATEDRYING
 s$ONOTUSEABRASIVECLEANS
Battery and Charging Safety
Battery
Do not attempt to replace the lithium-ion battery.
Do not attempt to replace the battery with non-approved batteries. Incorrect replacement of batteries could result in
damage to the device. The battery should only be replaced by ManaMed.
Be sure to only use the USB battery charger (Part Number PFCHG) provided with the system. Other chargers may cause the
battery to overheat and damage the battery, PlasmaFlow or the user.
Do not use an extension cord with the battery charger as it may cause overheating.
Do not use the battery charger with other devices as it may cause damage to the device or battery charger.
If the battery area on the PlasmaFlow system becomes overheated, discontinue using and contact ManaMed Customer
Service at 888-508-0712.
Charging
Important: Charge both devices before first use.
The battery will charge whether PlasmaFlow is turned on or off.
If the battery power decreases quickly even after recharging for four or more hours, contact Customer Service.
Do not recharge the battery in any of the following locations:
 s7HERETHETEMPERATUREISBELOW&#ORABOVE&#
 s!NYWHERENEARWATER
 s/UTDOORS
 s7ITHINREACHOFSMALLCHILDREN
 s!NYAREASWHEREPEOPLECOULDWALKONTHECHARGERCABLEORTRIPOVERTHECHARGERCABLE