M&M MONKEY JUMP User Manual

MM00125
HOW TO INFLATE INNER TUBE
1. Locate the valve extender. Unscrew and
remove the black cap on the end.
2. Next, take your inner tube and locate the
valve stem. Unscrew and remove the black
cap on the end.
3. Connect and thread the valve extender
onto the inner tube valve stem.
4. Aach your air chuck to the opposite end
of the valve stem extender. The use of a
needle valve tool is recommended.
5. Now that everything is connected, inate
the inner tube unl full. When inated,
the tube should measure approximately
20” high and ve feet wide. Standard inner
tube inaon to~6 psi (40kpa).
6. Once the tube is lled the valve stem
extender can be removed and the
black cap can be threaded back onto the
valve stem.
7. Slide the tube down over the top of the
Monkey Jump pole assembly. Make sure
the valve on the inner tube is facing down
toward the ground.
Valve Extender
Deated Inner Tube
Inated Inner Tube

M&M MONKEY JUMP Specifications

General

Brand	M&M
Model	MONKEY JUMP
Category	Play Sets & Playground Equipment
Language	English

Summary

How to Inflate Inner Tube

Inner Tube Leaking Air Troubleshooting

Inner Tube Maintenance Guide