Mangar Leglifter - Installation and Setup; Standard Fitting Instructions

Simple solutions for everyday independence
3
Leglier
Standard ng instrucons
• Fit the looped end of each strap around the
legs, castors or bed frame on the opposite side
of the bed (A g. 1) and pass the straps under
the maress.
• Fit the hook of each strap onto the Leglier
ap (B g.1) and posion the Leglier loosely
alongside the bed, clear of any obstacles such
as a bedside table.
• Tighten the straps to pull the edge of the ap
(‘Vee’ of deated Leglier) under the maress
by approximately 1 to 2 ngers width (C g.2).
• Connect the air hose from the Leglier to the
Airo 12 air outlet socket (D g. 3).
• Connect the hand control (E g. 3) to the hand
control socket (F g. 3).
• Press ‘Up’ on the hand control and check that
the Leglier inates to fully vercal against the
maress. Further ghten the straps if necessary.
NOTE: Upon nal adjustment, the edge of the ap
(‘Vee’ of deated Leglier - g. 2) should be about 1
to 2 ngers width from the edge of the bed frame/
maress. This will vary according to bed type e.g.
divan, sprung divan, narrow framed bed.
• Place the Airo 12 compressor by the side or
under the bed in an out of the way posion.
A
B
1 to 2 ngers
width
‘Vee’
C
1
2
3
E
D
F
‘Up’
‘Down’