Manitou 100 SEC 2 User Manual

3-7
MAINTENANCE TABLE
(1):COMPULSORY OVERHAUL AFTER 500 HOURS or 6 MONTHS
This overhaul must compulsorily be performed after approximately the first 500 hours of operation or 6 months after
the machine is put into service (when the earlier of the two periods is reached).
A = REGULATE, C = CHECK, G = GREASE, N = CLEAN,
P = BLEED, R = REPLACE, V = DRAIN
PAGE
(1)
DAILY OR
EVERY 10 HOURS
OF OPERATION
EVERY 50 HOURS
OF OPERATION
EVERY 250 HOURS
OF OPERATION
EVERY 500 HOURS
OF OPERATION
OR 6 MONTHS
EVERY 1000 HOURS OF
OPERATION
OR 1 YEAR
EVERY 2000 HOURS OF
OPERATION
OR 2 YEARS
EVERY 40000 HOURS
OF OPERATION
OCCASIONAL
TYRES
Wheel nuts
3-14 C C <<< <<< <<< <<< <<< <<<
Wheel and tyres 3-14/22 C C <<< <<< <<< <<< <<< <<< R
LIFTING STRUCTURE
Overload 3-16 C <<< <<< <<< <<<
Scissors skids 3-19 C/R <<< <<<
HYDRAULICS
Hydraulic oil
3-14/18 C C <<< <<< V/R <<< <<< <<<
Emergency descent 3-18 C C <<< <<< <<< <<< <<< <<<
Snifter cap 3-17 N <<< <<< <<< <<<
Hydraulic return oil filter cartridge 3-18 R R <<< <<< <<<
Hydraulic movement speeds 3-19 C** <<< <<<
Condition of the flexible tubing and rubber hoses 3-19 C** <<< <<<
Condition of the cylinders (leaks, cylinder rods) 3-19 C** <<< <<<
Hydraulic circuit pressures 3-20 C** <<<
Hydraulic circuit flows 3-20 C** <<<
ELECTRICITY
Condition of the joystick bellows
3-14 C <<< <<< <<< <<< <<< <<<
Tilt sensor 3-10 C C <<< <<< <<< <<< <<< <<<
Battery electrolyte level 3-15 C C <<< <<< <<< <<< <<< R
Battery electrolyte density 3-16 C C <<< <<< <<< <<<
Condition of the cables and the cable bundles 3-19 C** <<< <<<
TRANSMISSION
Braking
3-10
C C <<< <<< <<< <<< <<< <<<
Translation motor 3-17/19 C C C <<< <<<
Disc brake wear 3-21 C**
CHASSIS
Steering pivot axes
3-15 G <<< <<< <<< <<< <<<
LIFTING PLATFORM
General inspection
3-8 C C <<< <<< <<< <<< <<< <<<
Function control 3-8 C C <<< <<< <<< <<< <<< <<<
Safety stickers 3-17 C <<< <<< <<< <<<
Overload 3-18 C <<< <<< <<< <<<
Stopping Distance 3-18 C <<< <<< <<< <<<
Fitting slings on the lifting platform 3-23 XXX
(*): Every 10 hours for the first 50 hours and then a final time after 250 hours.
(**): Contact your dealer.
647369 (01/03/2017) 78/100 SEC 2 / 120 SE 2

Manitou 100 SEC 2 Specifications

General

Brand	Manitou
Model	100 SEC 2
Category	Forklifts
Language	English