Manitou A Series Operator's Manual

3 - 20
C6 - PARKING BRAKE
CHECK - ADJUST
Place the lift truck on a slope less than 15 % with the rated load in the
transport position.
- Check the tightening adjustment by locking the parking brake in position A
(Fig. C6).
- The adjustment is correct when the lift truck is held stationary on a slope.
- Carry out adjustments if necessary.
- Press and release the brake pedal, then release the parking brake, putting it
in position B (Fig. C6).
- Progressively tighten the end piece of the lever 1 (Fig. C6) and recheck
braking.
- Repeat the operation until the correct braking adjustment is obtained.
C7 - CAB VENTILATION FILTER (OPTION AIR
CONDITIONING
)
CHANGE
- Lift up protective casing 1 (Fig. C7).
- Lift out cabin ventilation filter 2 (Fig. C7) and fit new replacement filter (See
FILTERS CARTRIDGES AND BELTS in SECTION 3 - MAINTENANCE).
- Refit the protective casing.
C8 - HEATING BLOCK NON-RETURN VALVE
CLEAN
- Since non-return valve 1 (Fig. C8) is located under the cab, it is possible for
it to become obstructed with spattered mud for example. Clean if necessary.
C6
A
B
1
C8
1
C7
1
2
FORKLIFT SAFETY
CONTENTS

Manitou A Series Specifications

General

Brand	Manitou
Model	A Series
Category	Front End Loaders
Language	English