Manitou A Series Operator's Manual

3 - 35
BLEEDING THE INJECTORS
- Loosen high pressure connectors 5 (Fig. G1/5) of two of the injectors.
- Activate the starter until the diesel fuel flows out free of air at connections 5
(Fig. G1/5)
.
- Tighten the connection while the diesel fuel is flowing out (Tightening torque
22 N.m or 16 ft/lbs).
The I.C. engine is then ready to be started up.
NOTE: If the I.C. engine functions correctly for a short time then stops or
functions irregularly, check for possible leaks in the low pressure
circuit. If in doubt, contact your dealer.
G2 - W
HEEL
CHANGE
- Stop the lift truck, if possible on even and hard ground.
- For stopping and parking of the lift truck (See DRIVING INSTRUCTIONS in
SECTION 1 - OPERATING AND SAFETY INSTRUCTIONS).
- Put the warning lights on.
- Immobilize the lift truck in both directions on the axle opposite to the wheel
to be changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube, as near as possible to the wheel
and adjust the jack (Fig. G2/1).
- Lift the wheel until it comes off the ground and put in place the safety
support under the axle (Fig. G2/2).
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Refit the nuts by hand, if necessary grease them.
- Remove the safety support and lower the lift truck with the jack.
- Tighten the wheel nuts with a torque wrench (See A - DAILY OR EVERY 10
HOURS SERVICE in SECTION 3 - MAINTENANCE for tightening torque).
G1/5
5
5
5
5
G2/1
G2/2
Run the I.C. engine at idle for 5 minutes immediately
after bleeding the fuel feed circuit, in order to ensure
that the injection pump has been bled thoroughly.
IMPORTANT
Use extreme caution when changing tires on the
forklift - especially when parked near the public
highway.
WARNING
FORKLIFT SAFETY
CONTENTS

Manitou A Series Specifications

General

Brand	Manitou
Model	A Series
Category	Front End Loaders
Language	English