Manitou A Series User Manual

3 - 30
D11
1.240
1.250
1.260
1.270
1.280
1.290
1.300
-10
14
-18
0
°C
°F
0
32
10
50
20
68
30
86
40
104
D10
1
2
D9 - PARKING BRAKE MECHANISM
GREASE
- Clean and grease articulation axles 1 (Fig. D9) with grease (See chapter :
LUBRICANTS AND FUEL in paragraph : 3 - MAINTENANCE).
D10 - CAB VENTILATION FILTER
CLEAN
- Lift up protective casing 1 (Fig. D10).
- Lift out cabin ventilation filter 2 (Fig. D10).
- Clean the filter with a compressed air jet.
- Check its condition and change if necessary (See chapter : FILTERS CARTRIDGES
AND BELTS in paragraph : 3 - MAINTENANCE).
- Refit the filter and protective casing.
D11 - BATTERY ELECTROLYTE DENSITY
CHECK
The electrolyte density varies depending on the temperature concerned, but a minimum
of 1260 at 16°C must be maintained. In the shaded area (Fig. D11), the battery is in a
normal charge condition. Readings above this zone indicate that the battery needs to be
recharged.
The density should not vary more than 0.025 units between cells.
- Check the electrolyte density in each battery cell using a hydrometer.
- Do not carry out this check immediately after topping up with distilled water. Recharge
the battery for at least an hour before checking the battery electrolyte density.
Handling and servicing a battery can be dangerous, take the following precautions :
- Wear protective goggles.
- Keep the battery horizontal.
- Never smoke or work near a naked flame.
- Work in a well-ventilated area.
- In the event of electrolyte being spilled onto the skin or splashed in the eyes,
rinse thoroughly with cold water for 15 minutes and call a doctor.
D9
1
1

Manitou A Series Specifications

General

Brand	Manitou
Model	A Series
Category	Front End Loaders
Language	English