A7 - JIB PADS
CLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service, then once at 250
hours.
- Extend the jib completely.
- With a brush, apply a coat of grease (See chapter : LUBRICANTS AND FUEL in
paragraph : 3 - MAINTENANCE) on the 4 sides of the telescope(s) (Fig. A7).
- Telescope the jib several times in order to spread the coat of grease evenly.
- Remove the surplus of grease.
If the lift truck is used in an abrasive environment (Dust, sand, coal…) Use lubricating
varnish (MANITOU Reference : 483 536). In this respect, consult your dealer.
NOTE :
MT 732/932 Série A
MT 732 Turbo Série A
A jib sealing kit is available as an OPTION.
3 - 12
A7
MLT 629 . .....
MLT 633 . .....
A7
MLT 730 . .....
MT 732 . .....
A7
MT 932 Série A
To Next Page
Loading...
Need help?
General
