2-41
EN
IT
EN ESDE
OPTIONAL FUNCTIONS SWITCHES
ENGINE BRAKE SWITCH
The engine brake decelerates the telehan-
dler without using mechanical friction in
order to avoid the overheating of the brake
system.
This brake is mainly used in the long de-
scents, and it allows to brake the vehicle
without stressing the brakes.
Press the switch (2,
3.22) to enable (1a,
1b,
3.22) or disable (0,3.22) the en-
gine brake.
On the control panel an grey indicator
light (2a,
3.22) or yellow indicator light
(2b,
3.22) indicates that the function is
active .
On the switch (2,
3.22) the LED
(1,
3.22) comes on to indicate that the
function is active.
The engine brake allows two stages of de-
celeration (0, 1a, 1b,
3.22), a low and an
intense one.
Operating conditions of the engine brake.
The engine brake only works if:
- the engine water temperature is > 60°C
- the accelerator pedal is not pressed
- the revs of the I.C. engine are > 1100
rpm.
p
IMPORTANT! In order to main-
tain the braking power of the
engine brake, the speed shall
not exceed 42 km/h. If required,
slow down the machine by press-
ing the service brake pedal.
If the speed of the machine ex-
ceeds 42 km/h, the driver will be
warned by an alarm sound and
an optical signal “BRAKE” on the
tachometer.
1
0
1a
1b
2
2b
2a
3.22
INTERRUTTORI FUNZIONI OPTIONAL
INTERRUTTORE FRENO MOTORE
Il freno motore decelera il sollevatore te-
lescopico senza usare frizione meccanica
per evitare il surriscaldamento del sistema
frenante.
Questo freno è principalmente utilizzato
nelle lunghe discese, e permette di frenare
la macchina senza sollecitare i freni.
Premere l’interruttore (2,
3.22) per at-
tivare (1a, 1b,
3.22) o disattivare (1a,
0,
3.22) il freno motore.
Sul pannello di controllo una spia grigia
(2a,
3.22) o una gialla (2b,3.22) indica
che la funzione è attiva .
Sull’interruttore (2,
3.22) il led si accende
(1,
3.22) per indicare che la funzione è at-
tiva.
Il freno motore consente due fasi di decele-
razione (0, 1a,1b,
3.22) una bassa ed una
intensa.
Condizioni di funzionamento del freno mo-
tore.
Il freno motore funziona solo se:
- l’acqua motore è > 60 °C
- il pedale dell’acceleratore non è premuto
- i giri del motore termico sono > di 1100
rpm.
p
IMPORTANTE! Per mantenere
la massima potenza frenante
del freno motore, non supe-
rare i 42 km/h di velocità. Se
necessario rallentare la velo-
cità della macchina premendo
il pedale dei freni di servizio.
Se la velocità della macchina su-
pera i 42 km/h, il guidatore viene
avvisato da un allarme sonoro e
da una segnalazione ottica su ta-
chimetro “BRAKE” (frenare).
SCHALTER OPTIONALFUNKTIONEN
SCHALTER MOTORBREMSE
Die Motorbremse verlangsamt den Teles-
koplader, ohne die mechanische Kupplung
zu benutzen, um eine Überhitzung des
Bremssystems zu vermeiden.
Diese Bremse wird vor Allem bei langen
Bergab-Fahrten benutzt und erlaubt die
Maschine zu bremsen, ohne die Bremsen zu
beanspruchen.
Den Schalter (2,
3.22) drücken, um die
Motorbremse zu aktiveren (1a, 1b,
3.22)
oder zu deaktivieren (1a, 0,
3.22).
Auf der Steuertafel zeigt eine graue
(2a,
3.22) oder eine gelbe Kontrollleuchte
(2b,
3.22) an, dass die Funktion aktiv ist.
Auf dem Schalter (2,
3.22) leuchtet die
LED (1,
3.22) auf, um anzuzeigen, dass die
Funktion aktiv ist.
Die Motorbremse ermöglicht zwei Abbrem-
sungsphasen (0, 1a,1b,
3.22): eine niedri-
ge und eine intensive.
Betriebsbedingungen der Motorbremse.
Die Motorbremse funktioniert nur, wenn:
- die Kühlmitteltemperatur > 60°C
- das Gaspedal nicht gedrückt ist
- die Verbrennungsmotordrehzahl > 1100
UpM.
p
WICHTIG! Um die maximale
Bremsleistung der Motorbrem-
se beizubehalten, darf die Ge-
schwindigkeit von 42 km/h nicht
überschritten werden. Ggf. die
Geschwindigkeit der Maschi-
ne durch Drücken des Pedals
der Betriebsbremsen drosseln.
Wenn die Geschwindigkeit der
Maschine die 42 km/h überschrei-
tet, wird der Fahrer durch einen
Alarmton und die Anzeige am
Tachometer "BRAKE" (bremsen)
gewarnt.
648970 IT-EN-DE (04/10/2016)
MRT-X 2470 Privilege Plus ST3A S1, MRT 2470 Privilege Plus ST4 S1, MRT-X 3050 Privilege Plus ST3A S1, MRT 3050 Privilege Plus ST4 S1