2-33
INFO CLOCK<>LCD OPT
09:35
10/06/2010
MENU SCREEN
- Press the
button to display the menu screen with the time and date. Navigate horizontally between menus using the
buttons and vertically in the sub-menus using the buttons .
INFO
Time and date (by default).
Lift truck in degraded mode and/or fault detected (see error code table).
“Check Maintenance” appears for a few seconds if maintenance is necessary.
CLOCK
HOUR: Change the hour.
DATE: Change the date.
FORM: Change the time or date format.
LCD
BACKL: Backlight.
CONTR: Contrast.
OPT
The contents of this menu can be accessed by means of a customer password.
RST H: Resetting of daily hour counter to zero, permitted (by default) or not permitted.
PARK: Hand-operated parking brake or automatic (by default).
CFLOW: Forced operation without driver presence permitted or not permitted (by default).
LLMC: Disabling of aggravating hydraulic movement cut-off permitted (by default) or not permitted.
PASS: Fault override permitted or not permitted (by default).
UNIT: Speed of travel displayed in MPH or Km/h (by default).
DIGI1: Digicode enabled or not enabled (by default).
DIGI2: Change the 4 figure digicode (lift truck start-up).
CUST: Change the customer code.
DIAG
The contents of this menu enables your dealer to perform a diagnosis on the Man-Machine Interface.
XPRT
RESET > HOURM: Reset the partial hour meter to zero.
MAINT: Reset the maintenance interval to 500 hours.
ADMIN > ADMIN: Change the administrator code.
ERASE > MC: Clear faults from the computer of the Man-Machine Interface.
MP1: Clear faults from computer MP1.
MP2: Clear faults from computer MP2.
CALIB > SECU: Calibration of jib angle and strain gauge.
GAUGE: Recalibration of strain gauge.
To Next Page
Loading...
