EasyManuals Logo

Manitou MT 732 Operator's Manual

Manitou MT 732
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
3-10
A = ADJUST, C = CHECK, G = GREASE, N = CLEAN,
P = BLEED, R = REPLACE, V = DRAIN
PAGE
(1)
DAILY OR EVERY 10
HOURS SERVICE
EVERY 50 HOURS
SERVICE
EVERY 250 HOURS
SERVICE
EVERY 500 HOURS
SERVICE OR 6
MONTHS
EVERY 1000 HOURS
SERVICE OR 1 YEAR
EVERY 2000 HOURS
SERVICE OR 2 YEARS
EVERY 4000 HOURS
SERVICE
OCCASIONALLY
I.C. ENGINE
I.C. engine oil level
3-12 C C <<< <<< <<< <<< <<< <<<
Cooling liquid level
3-12 C C <<< <<< <<< <<< <<< <<<
Fuel level
3-12 C C <<< <<< <<< <<< <<< <<<
Fuel pre-filter
3-13 C C <<< <<< <<< <<< <<< <<<
Cyclonic pre-filter
3-13 N N <<< <<< <<< <<< <<< <<<
Dry air filter cartridge
3-18/29 R C/N <<< R <<< <<< <<<
Radiator cores
3-18 N N <<< <<< <<< <<< <<<
Condenser core (OPTION Air conditioning)
3-18 C/N C/N <<< <<< <<< <<< <<<
Fan belt tension
3-24 A C/A <<< <<< <<< <<<
Alternator/crankshaft belt tension
3-24 A C/A <<< <<< <<< <<<
Compressor belt tension (OPTION Air conditioning)
3-25 A C/A <<< <<< <<< <<<
I.C. engine oil
3-28 V V <<< <<< <<<
I.C. engine oil filter
3-28 R R <<< <<< <<<
Fuel pre-filter
3-29 R R <<< <<< <<<
Fuel filter
3-30 R R <<< <<< <<<
CLEANFIX compressor filter (OPTION)
3-30 R R <<< <<< <<<
Fuel tank
3-34 N <<< <<<
Safety dry air filter cartridge
3-34 R <<< <<<
I.C. engine silent blocks
C** <<< <<<
I.C. engine rates
C** <<< <<<
Valves clearances
C** C** <<< <<<
Cooling liquid
3-38 V <<<
Radiator
C** <<<
Water pump and the thermostat
C** <<<
Alternator and the starter motor
C** <<<
Turbocompressor
C** <<<
Fuel system
3-40 P
TRANSMISSION
Oil levelgear box
3-13 C C <<< <<< <<< <<< <<< <<<
Angle gear box oil level
3-25 C C <<< <<< <<< <<<
Gear box oil filter
3-31 R R <<< <<< <<<
Gear box oil
3-35 V V <<< <<<
Gear box sump strainer
3-35 N N <<< <<<
Angle gear box oil
3-36 V V <<< <<<
Silentblocks in the gear box
C** <<< <<<
Gear box controls
C** <<< <<<
Gear box pressures
C** <<<
Converter pressure
C** <<<
TYRES
Tyres pressure
3-13 C C <<< <<< <<< <<< <<< <<<
Wheel nuts torque
3-13 C C <<< <<< <<< <<< <<< <<<
Condition of wheels and tyres
C** <<< <<<
Wheel
3-40 R
BOOM
Boom pads
3-14 G* <<< <<< <<< <<< <<< <<<
Boom
3-19 G G <<< <<< <<< <<< <<<
Boom pads wear
C** <<< <<<
Condition of boom unit
C** <<<
Bearings and articulation rings
C** <<<
HYDRAULIC
Hydraulic oil level
3-20 C C <<< <<< <<< <<< <<<
Hydraulic return oil filter cartridge
3-31 R R <<< <<< <<<
Hydraulic oil
3-36 V <<< <<<
Suction strainer for hydraulic oil tank
3-36 N <<< <<<
Filter cap for hydraulic oil tank
3-36 R <<< <<<
Speeds of hydraulic movements
C** <<< <<<
Hydraulic pump pipe filter
N** <<< <<<
Condition of hoses and flexible pipes
C** <<< <<<
Condition of cylinders (leakage, shafts)
C** <<< <<<
Hydraulic circuit pressures
C** <<<
Hydraulic circuit outputs
C** <<<
Hydraulic oil tank
N** <<<
SERVICING SCHEDULE
(1): MANDATORY 500 HOUR OR 6 MONTH SERVICE
This service must be carried out after approximately the first 500 hours of operation or within the 6 months following the start-up of the machine (whichever
occurs first).
647083 EN (21/06/2011)

Table of Contents

Other manuals for Manitou MT 732

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MT 732 and is the answer not in the manual?

Manitou MT 732 Specifications

General IconGeneral
BrandManitou
ModelMT 732
CategoryFront End Loaders
LanguageEnglish

Related product manuals