3-14
A8 - BOOM PADS
CLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service, then once at 250 hours.
- Extend the boom completely.
- With a brush, apply a coat of grease (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) on the 4
sides of the telescope(s) (fig. A8).
- Telescope the boom several times in order to spread the coat of grease evenly.
- Remove the surplus of grease.
If the lift truck is used in an abrasive environment (dust, sand, coal…) Use lubricating varnish (MANITOU
reference: 483536). In this respect, consult your dealer.
NOTE: A boom sealing kit is available as an OPTION.
A8
To Next Page
Loading...
Need help?
General
