General Information Section 1
6
Part Number 000007345 2/14
All covers and access panels must be in place and
properly secured, before operating this equipment.
Do not obstruct machine vents or openings.
Do not store gasoline or other flammable vapors or liquids
in the vicinity of this or any other appliance.
Do not clean with water jet.
It is the responsibility of the equipment owner to perform
a Personal Protective Equipment Hazard Assessment to
ensure adequate protection during maintenance
procedures.
Two or more people are required to move this equipment
to prevent tipping.
Manitowoc ice machines require a deflector when
installed on an ice storage bin. Prior to using a non-
Manitowoc ice storage system with Manitowoc ice
machines, contact the manufacturer to assure their
ice deflector is compatible with Manitowoc ice
machines.
Some 50 hz models may contain up to 150 grams of
R290 (propane) refrigerant. R290 (propane) is
flammable in concentrations of air between
approximately 2.1% and 9.5% by volume (LEL lower
explosion limit and UEL upper explosion limit). An
ignition source at a temperature higher than 470°C is
needed for a combustion to occur. Refer to nameplate
to identify the type of refrigerant in your equipment.
Only trained and qualified personnel aware of the
dangers are allowed to work on the equipment.
When using electric appliances, basic precautions must
always be followed, including the following:
a. Read all the instructions before using the
appliance.
b. To reduce the risk of injury, close supervision is
necessary when an appliance is used near
children.
c. Do not contact moving parts.
d. Only use attachments recommended or sold by
the manufacturer.
e. Do not use outdoors.
f. For a cord-connected appliance, the following
must be included:
• Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
• Unplug from outlet when not in use and
before servicing or cleaning.
• Do not operate any appliance with a
damaged cord or plug, or after the appliance
malfunctions or is dropped or damaged in
any manner. Contact the nearest authorized
service facility for examination, repair, or
electrical or mechanical adjustment.
g. Follow applicable lock out tag out procedures
before working on equipment.
h. Connect to a properly grounded outlet only.
Remove all ice machine panels before lifting and
installing.
Objects placed or dropped in the bin can affect
human health and safety. Locate and remove any
objects immediately.
To Next Page
Loading...
Need help?
General