Section 4 Maintenance
Part Number 040001361 05/10 17
Step 9 Mix 1 oz (2 tablespoons) sanitizer with 2 gal of
warm water.
Step 10 Use 1/2 of the sanitizer/water mixture to
sanitize all removed components. Use a cloth or sponge
to liberally apply the solution to all surfaces of the
removed parts or soak the removed parts in the
sanitizer/solution. Rinsing is not required.
Step 11 Use the other 1/2 of the sanitizer/water solution
and a sponge or cloth to sanitize the inside of ice bin.
Sanitize inside of door, door gasket, bin, top of
evaporator and evaporator bucket. Rinsing is not
required.
Step 12 Replace all removed components.
Step 13 Prepare 1/2 oz (1 tablespoon) of undiluted
Manitowoc Sanitizer.
Step 14 Reapply power to the ice machine, then press
the Clean switch.
Step 15 Wait 3 minutes until the Clean light flashes,
then add the prepared Manitowoc Sanitizer by lifting the
water shutters and pouring directly into the spray area.
The ice machine will automatically time out a ten minute
sanitizing cycle, followed by eight rinse cycles, and stop.
The Clean light will turn off to indicate the sanitizing
cycle is complete. This entire cycle lasts approximately
30 minutes.
NOTE: The ice machine will automatically continue from
the previous point before the clean cycle was initiated.
A. If the ice machine was in the ice making cycle,
the control board will start ice making again.
B. If the ice machine was in the off cycle, the
control board will turn off.
REMOVAL OF PARTS FOR CLEANING/SANITIZING
1. Turn off the electrical and water supply to the ice
machine.
2. Remove all ice from the bin.
3. Remove the components that must be cleaned and
sanitized. See the following pages for removal
procedures for these parts.
4. Soak the removed part(s) in a properly mixed
solution of cleaner.
5. The cleaner will foam; once the foaming stops use a
soft-bristle nylon brush, sponge or cloth (NOT a wire
brush) to carefully clean the parts.
6. Thoroughly rinse all the parts with clear water.
7. Soak the removed parts in a properly mixed solution
of sanitizer for 5 minutes.
8. Use a soft-bristle nylon brush, sponge or cloth (NOT
a wire brush) to carefully sanitize the parts.
9. Use the sanitizing solution and a sponge or cloth to
sanitize (wipe) the interior of the ice machine and
bin.
10. Rinsing is not required when using Manitowoc
Sanitizer.
11. Install the removed parts.
12. Turn on the water and electrical supply.
Model Sanitizer Amount Water Amount
SM50 1 oz. (30 ml) 2 gal (8L)
Disconnect electric power to the ice machine before
proceeding.
Wear rubber gloves and safety goggles (and/or face
shield) when handling Cleaner or Sanitizer.
Solution Type Water Mixed With
Cleaner 1 gal. (4 l) 8 oz (240 ml) cleaner
Sanitizer 2 gal. (8 l) 1 oz (30 ml) sanitizer
Do not immerse the water pump motor in the
cleaning or sanitizing solution.
To Next Page
Loading...
Need help?
General
