Need help?Do you have a question about the Mannesmann Rexroth A10VSO Series and is the answer not in the manual?
General| Brand | Mannesmann Rexroth |
|---|---|
| Model | A10VSO Series |
| Category | Water Pump |
| Language | English |
Diagram showing size 100 and 140 with mechanical adjustable min flow stopper.
Details on sealing sets, drive shafts, bearing kits, rotary groups, and swash plates.
Information on control device parts, pilot valves, and specific valve designs.
Step-by-step guide for removing and replacing the drive shaft sealing ring.
Disassembly of pilot valve, port plate, bearings, shims, and rotary group.
Removing bearing shells, control plate, and outer bearing races.
Disassembling piston guides, drive shaft, and cylinder parts.
Notes on bearing tension, valve plate fitment, and piston running conditions.
Notes on spare parts service and control valve modification procedures.
Fitting instructions for various control valve DFR configurations.
Steps for loosening screws, removing O-rings, and blowing out orifices.
Disassembling nuts, pins, springs, and plugs from the valve.
Careful disassembly of pistons and orifices, and cleaning procedures.
Assembling the pilot valve and adjusting the bypass orifice.
Table for flow limiter adjustments and procedure for setting bearing initial tension.
Adjusting pressure and flow controllers and mechanical flow limiters.
Recommended Loctite products and bolt tightening torque values.
To Next Page
