MA409
3
EN
WIRELESS MICROPHONE SYSTEM
INSTRUCTION
You will be grateful that you have purchased one of our products. Wireless
microphone system is made up of double channel receiver and tow wireless
microphone A and B. Before using, please read the instruction carefully.
USING METHODS:
1. Connect the unit with the mains.
2. Connect the receiver and the input socker of HI-FI with cords. Draw
out the antenna.
3. Turn on the power of the HI-FI. Adjust to a suitable volume. Press
the power switchon the receiver, Once the red light on the receiver
is lit. It means your receiver works normally.
4. Remove the case of the microphone, install a 9V battery. Then put
the power switch on the tail end of the microphone to “ON” posi-
tion. After tightening the ease rmly. The power light will light up.
The colour of A microphone indicated red, and B is green, which is
same as the receiver. This shows that the system is working mor-
king normally. Adjust a suitable volume
5. Microphone must not face the loud speaker, to avoid causing a
sharp sound,
6. After using, turn the switch to “OFF” position to save battery. Turn
o the power of the receiver, and put the cord out of power.
WARNINING:
1. When the microphone is not in use, please remove the battery.
2. When the sound gets weak, please change the battery.
3. Always use good quality batteries.
4. The microphone system has been pre-set optimum results.
To Next Page
Loading...