8
CLEAR SINGLE PROGRAM
1. Press SHARE/9/VIEW + OPTIONS/10/MENU, hold for 3 seconds until the green LED is on.
2. Press programmed button and the green LED starts blinking.
3. Press programmed button again and the green LED is off. Single programmed button is cleared.
CLEAR ALL PROGRAMS
1. Press SHARE/9/VIEW + OPTIONS/10/MENU, hold for 3 seconds until the green LED is on.
2. Press OPTIONS/10/Menu and hold for 4 seconds. The green LED is off. All of the programmed buttons are
cleared. Default is restored.
PROGRAM PEDALS AS Y AXIS
1. Press SHARE/9/VIEW + OPTIONS/10/MENU. Hold for 3 seconds until the green LED is on.
2. Press LEFT of the D-PAD. The green LED is off. Pedals are programmed as Y function.
PROGRAM L-WING AND R-WING AS Y AXIS
1. Press SHARE/9/VIEW + OPTIONS/10/MENU. Hold for 3 seconds until the green LED is on.
2. Press RIGHT of the D-PAD. The green LED is off. Pedals are programmed as Y function.
CLEARANCE THE L/R-WING OR PEDAL AS Y AXIS
1. Press SHARE/9/VIEW + OPTIONS/10/MENU for 3s Green LED On.
2. Press the L/R-wing or pedal which fixed as Y axis, Green LED blinking.
3. Press the L/R-wing or pedal which fixed as Y axis, Green LED off to clear.
Note: All of the settings will cleared when the wheel is power off.
LEVELS WHEEL SENSITIVITY ADJUSTMENT
3 level Sensitivity switch (LO – MID – HI) Low, Middle, High.
PLATFORMS
FOR USE WITH PS3
1. Connect the wheel to PS3 console; and connect the pedal to the wheel, power on PS3 console.
2. The active channel LED indicator will light up when connection finished automatically.
3. Then you can set up or start the game.
4. During PS3 game play, press the HOME button once to enter the XBM window. Press and hold the MODE
button to enter MENU setup window.
FOR USE WITH PS4
1. Connect the wheel to PS4 console; and connect the pedal to the wheel, Power on PS4 console.
2. Connect the racing wheel to original PS4 controller by a USB cable, consider the controller as a key to establish
the connection between the controller and racing wheel (the controller need to be power off).
3. After the connection been established, the RED LED is on, press the Wheel HOME button, then you can start
the game or the settings.
4. During PS4 game play, press the HOME button once to enter the XBM window.
Note: The controller does not need to be original PS4 controller, it can be third party licensed controller.
To Next Page
Loading...