5
CHARGING
NOTE: CHARGE THE WORK LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND AT LEAST EVERY 3
MONTHS WHEN NOT IN USE. Failure to do this will reduce
the battery’s useful life.
Connect the microUSB end of the charging cable to the
microUSB port on the work light. Connect the USB end of the
charging cable to the USB port of the AC charger. Plug the
AC charger into a functioning AC outlet.
The blue state of charge / charging status LEDs will blink
in succession to indicate charging progress. To reach full
charge, continue charging until all four LEDs are lit solid.
Charging will take approximately 4 hours, depending on the
unit’s state of charge at the start of the cycle.
The charging process is fully automatic and the light can
remain connected to the charger indenitely without adverse
consequences.
To Next Page
Loading...
Need help?
General
