6
OPERATING INSTRUCTIONS
Do not turn on the work light while it is being charged.
Direct the lens away from your eyes before turning on the
work light.
Press the POWER button to achieve the operational mode
desired:
– Press POWER for COB Work Light low brightness mode.
– Press POWER a second time for COB Work Light high
brightness mode.
– Press POWER a third time for Focus Beam Light mode.
– Press POWER a fourth time to turn the unit OFF.
The unit incorporates a rotating arm with an integrated mag-
net in its base for ideal positioning, allowing it to be attached
to any ferrous metal surface.
Recharge the work light after use, and at least every 3
months when not is use.
MAINTENANCE INSTRUCTIONS
After use and before performing maintenance, disconnect
the work light from the charger.
Use a dry cloth to wipe any dirt or oil from the charger, cord
and light.
Any servicing should be performed by qualied service
personnel.
To Next Page
Loading...
Need help?
General
