Mantis LNCMINI User Manual

COB LED Rechargeable Work Light
Operator’s Manual
Model No. LNCMINI
WARNING
Read these instructions completely before using the Jump-N-Carry and save them for
future reference. Before using the Jump-N-Carry to jump start a car, truck, boat or to
power any equipment, read these instructions and the instruction manual/safety
information provided by the car, truck, boat or equipment manufacturer. Following all
manufacturers’ instructions and safety procedures will reduce the risk of accident.
Working around lead-acid batteries may be dangerous. Lead-acid batteries release
explosive gases during normal operation, charging and jump starting. Carefully read and
follow these instructions for safe use. Always follow the specific instructions in this
manual and on the Jump-N-Carry each time you jump start using the Jump-N-Carry.
All lead-acid batteries (car, truck and boat) produce hydrogen gas which may violently
explode in the presence of fire or sparks. Do not smoke, use matches or a cigarette
lighter while near batteries. Do not handle the battery while wearing vinyl clothing
because static electricity sparks are generated when vinyl clothing is rubbed. Review all
cautionary material on the Jump-N-Carry and in the engine compartment.
Always wear eye protection, appropriate protective clothing and other safety equipment
when working near lead-acid batteries. Do not touch eyes while working on or around
lead-acid batteries.
Always store clamps in their holsters, away from each other or common conductors.
Improper storage of clamps may cause the clamps to come in contact with each other,
or a common conductor, causing the battery to short circuit and generate high enough
heat to ignite most materials.
Use extreme care while working within the engine compartment, because moving parts
may cause severe injury. Read and follow all safety instructions published in the vehicle's
Owner's Manual.
While the battery in the Jump-N-Carry is a sealed unit with no free liquid acid, batteries
being jump started with the Jump-N-Carry unit likely contain liquid acids which are
hazardous if spilled.
Failure to follow instructions may
cause damage or explosion,
always shield eyes. Read entire
instruction manual before use.
WARNING
WARNING: This product can expose you to chemicals
including Vinyl-Chloride, Styrene and Acrylonitrile, which are
known to the State of California to cause cancer and birth
defects or other reproductive harm. Wash hands after handling.
For more information go to www.P65Warnings.ca.gov.

Mantis LNCMINI Specifications

General

Color	Black
Charging Time	3 hours
Battery Type	Lithium-ion
Material	Aluminum
Lumens	1000 Lumens

Summary

Mantis Work Light Operator's Manual

General Safety Warning

Failure to follow instructions may cause damage or explosion; shield eyes and read manual.

California Proposition 65 Warning

Product contains chemicals known to cause cancer and reproductive harm.

Owner's Manual and General Safety

Manual Usage and Warranty Service

Save the owner's manual and contact Technical Service for warranty or performance issues.

Battery Maintenance and Charging

Keep the sealed lithium battery at full charge; recharge after each use and every six months if unused.

Operational Safety Advice

Wear eye protection and use caution near moving parts for safe operation.

Important Safety Instructions

Prohibited Actions During Charging

Do not turn on, handle, or move the work light while it is being charged.

Light Usage Restrictions

Do not look directly into the light, allow children to use it, or operate if damaged.

Battery Care and Charger Use

Do not let the battery remain discharged; use only the provided AC charger indoors.

Personal Safety and Product Features

Handling and Environmental Safety

Do not disassemble the light; avoid temperatures above 140°F and dispose of battery properly.

Work Light Features List

Includes COB LED, focus beam, charging indicators, magnet, and USB charging capabilities.

Charging the Work Light

Charging Steps and Indicators

Connect microUSB and USB ends, plug into AC outlet; LEDs indicate charge status.

Charging Duration and Safety

Charging takes ~4 hours; the unit can remain connected indefinitely without adverse effects.

Operation and Maintenance

Work Light Operating Modes

Press POWER button to cycle through COB low/high brightness and focus beam modes.

Unit Positioning and Recharge Reminder

Use rotating arm and magnet for positioning; recharge after use and every 3 months.

Maintenance and Servicing

Disconnect charger before maintenance; clean with a dry cloth; servicing by qualified personnel only.

Storage and Replacement Parts

Storage Conditions and Battery Life

Store in a cool, dry place; avoid damage; charging before storage preserves battery life.

Replacement Charger Kit

Charger replacement kit (Part NO. LNC215) includes wall charger and USB/microUSB cable.

Limited Warranty Details

Warranty Coverage and Exclusions

One-year warranty on defects, void if abused; accessories not covered; liability limited.

State-Specific Warranty Rights

Some states limit warranty limitations; you may have additional rights varying by state.

Service and Product Registration

Warranty Service Procedure

Return product to place of purchase for exchange if defective within the warranty period.

Registering Your Purchase Online

Visit cloreregistration.com to register your product for service and updates.

Contacting Technical Support

Contact Clore Automotive Technical Service for questions, out-of-warranty service, or warranty information.