17
i) The appliance is not energised/the “START” buton is not pressed.
ii) The cooker is not fully closed and the 2 way safety button is not turned to “close” position.
iii) There is insufficient liquid in the cooker for steam generation.
Determine the reason and take corrective action without touching any hot parts of the cooker. Reset the cooker
and start the cooking process.
12 . Once the cooking cycle is complete, the unit will give 4 beeps and will go into “WARM” mode and the
display will indicate “ ” This will stay in warm mode till the “CLR/OFF” button is pressed. Press “CLR/
OFF” button (third from the top) until the indicator goes off and then remove the cooker from the electric unit
(plastic base).
13. Using the handles of the body remove the cooker from the electric unit (plastic base). The lid
and body surfaces may be hot. Be carefull not to touch any hot surfaces.
14. Your cooker is equipped with the Quick Release System (QRS). If you wish to operate the
QRS, remove the cooker using the body handles from the electric unit. (Refer point no. 13) Turn
the pressure regulator by aligning the tang of the pressure regulator to the steam release posi-
To Next Page
Loading...