3
D00729EN - v2 DDS-SSENSOR - INSTALLATION MANUAL
Tape measure
Spirit level
Drill
Flathead screwdriver
Drill Bits:
Ø 3
Ø 8
Mounting template
1.2 TOOLS REQUIRED
1.3 SAFETY INSTRUCTIONS
All national and international provisions relating to door safety must be observed. The installation and commissioning of the
sensor should only be carried out by authorised technical staff. Any servicing or repair works on the sensor should only be
carried out by manusa.
Any other use of the device different from its intended purpose shall be excluded from the manufacturer’s guarantee.
This device may only be operated with protective low voltage (SELV) with safe electrical insulation.
The installing company shall be responsible for the correct installation of the sensor and the door safety elements.
The manufacturer shall not be liable for incorrect sensor installations or inappropriate settings which have not been
implemented by manusa.
When handling the sensor, great care must be taken in order not to interfere with its correct operation.
To Next Page
Loading...
Need help?
General