10
DTCXSL02EN - v2
2 - WIRING TO THE DRIVE (BUS)
A 10 mt. cable is delivered with the selector, which includes
a connector ready to plug-in, and an additional connector in
case you need to cut-down the cable length. Follow these
instructions to cut the cable:
1. Cut the cable to the required distance .
2. Peel off the wire as shown below, leaving 6 mm (+/-
1mm) on the 4 wires to allow fitting the connector.
3. Check that the wires are clean and there is no contact
between the 4 wires, as this may cause a short-circuit.
4. Fit the wires into the connectors. Check polarity as
shown in the drawing below, making sure that the flap of
the connector on one end is facing the cable nerve, and
the flap from the opposite connector is facing the opposite
side of the cable.
5. Use the crimp tool to crimp the connector
1 2
6. Check that the connector is fixed to the cable housing
and that the metal tips of the connector make contact with
the wires.
Connect both ends of the cables to the RJ-10 termi-
nals on the control panel and selector, and let the
selector configure itself automaticaly and get ready
for use. During this process you may see the mes-
sage “LOADING DATA” for a few seconds on the
LCD display.
If the operating mode is not shown after 20 seconds,
press the 3 buttons simultaneously until the message
“ADDRESS RESET” is shown on the display.
If a second selector will be used, this can be plugged
to the RJ-10 connector on the control panel or to any
other accessory already plugged to it.
Remark: Do not connect the second selector until the
first one is in operation!
Use the cable supplied with the operator to connect the
selector to the terminals on the control panel.
To Next Page
Loading...