11
4 - SELECTOR ASSEMBLY
If recessed mounted
1 2
3. Screw the box to the desired surface through the holes
made to this effect. Clip the circuit with LCD panel to the
plastic box, making sure that the 3 buttons are facing down.
4. Fit the selector cover, with the 3 buttons in the control
circuit facing the buttons on the cover.
DTCXSL02EN - v2
5 - TECHNICAL FEATURES
6 - COMPATIBILITY
The SMART selector is only compatible with the manusa
VISIO operator.
Power supply
12 V DC
Power consumption
6 mA
Operating temperature
0 to 50ºC
Measurements:
100x75x26 mm
Maximum length of cables
10m
7 - SELECTION OF THE DOOR OPERATING MODE
You can choose the door operating mode by pressing
the left or right selection buttons. Area 6 of the
selector will blink with the icon of the mode selected.
Use the central confirmation button to accept the
mode.
OPEN MODE
The door will open and stay in that position. In this
mode, the leaves can be moved manually.
CLOSE MODE
In doors without auto lock, this operating mode
closes the door and releases the leaves. In
doors with auto lock, the leaves will close and
will become blocked.
Note: if the interior detector or pushbutton is
activated during the closing cycle, the leaves will
reopen and will then reattempt a new closing cycle
until the leaves are fully closed.
*Whenever required, the Technical Service may configure the
door to delay the activation of the lock, to let the user reach the
door and exit the premises before the leaves become blocked.
AUTOMATIC MODE
The door will complete a full open & closing cycle
each time a detector (interior or exterior) is activated.
EXIT ONLY MODE
The door will only open when the interior detector or
push button is activated.
*Note: if the door has an automatic lock, the
Leaves will remain blocked until they are in
closed position.
To Next Page
Loading...