EasyManua.ls Logo

MAPLE M-321 - Location and Installation

Default Icon
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
LOC
A
TIO
N
A
N
D
I
N
ST
A
LLA
TIO
N
Proper planning is an important consideration when installing your new
spa / hot tub. Site selection is a critical step and requires serious
thought. Planning ahead makes the installation process easier. The
following information is provided to assist you in site preparation.
1.
Always comply with local building codes and obtain any necessary permits. You
may also need to consult with an engineer to address your specific design needs.
2.
Contact an electrician to assess your electrical needs, install wiring, and assure a safe
operation.
3.
Position your spa / hot tub with proper access to water, drainage, and electricity.
4.
Place your spa / hot tub on a uniform solid, flat surface designed to properly
support its weight. For external installations, a 4-inch (10 cm) thick cement pad
suffices.
5.
For internal installations, check the load carrying capabilities of the floor on which
the spa will reside. Most homes meet the requirement of 250 pounds per square
foot.
6.
Assure that your spa / hot tub will fit into the space you have chosen and the
delivery route will accommodate its large size.
7.
Provide adequate ventilation for the humidity created by your spa / hot tub. In
most cases, the Color Coordinated Cover is sufficient.
8.
Protect the pump and all equipment from the weather by ensuring the cabinet
panels are secure at all times.
9.
Allow 36 inches (1 meter) of unobstructed access to all sides of your spa / hot tub
for normal servicing. Your spa / hot tub is not designed to be recessed in the
ground or in a deck.
10.
Consider positioning your spa / hot tub out of or adequately protecting it
from the wind. Just as people can get cold on cool / windy days so can your
spa / hot tub. Windy environments can significantly increase operating costs.
11.
Consider using an insulating pad. In cold climates, the ground can rob
heat from the spa / hot tub and increase your operating costs. Consider
using a suitable, outdoor insulating pad in such environments.
Figure 1 – Espace requis (dégagement) et support