MAPLE M-321 - Safety Instructions for Products

15
SAFETY INSTRUCTIONS FOR PRODUCTS
WARNING
C
HEMICAL HANDLING SAFETY HINTS INITIAL WATER FILL & BALANCE

Never pre-mix chemicals with each other prior to adding to hot tub water.

Add only one chemical to the water at a time.

Always add chemicals to water and not vice-versa.

Chemicals may be corrosive, so handle with care and store in a cool dark place.

Never smoke near chemicals as most are flammable

Ensure any spilled chemicals are carefully cleaned up immediately.

Always have the POISON CONTROL telephone number handy in the event of
an emergency.

Keep chemicals out of children ‘s reach

Wear safety glasses and gloves when handling chemicals.
INITIAL WATER FILL & BALANCE
1
Make sure the hot tub water is circulating and above 20°C (68°F)
2
Add a sequestrant (stain and scale controller). Allow water to circulate for an hour
before adding anything else to the hot tub water.
3
Add a Shock / oxidizing agents.
4
Add sanitizing tablets (Bromine or Chlorine)
It is important to check that there is
always one (or two) cartridge (s) in
the skimmer and that it is well
screwed.
The ideal water level is right under
the headrests.