Need help?Do you have a question about the Marantz 1060 and is the answer not in the manual?
General| Power Output | 30 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.5% |
| Damping Factor | 45 |
| Input Sensitivity | 1.8mV (MM), 180mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
Provides context and target audience for the service manual.
Details signals from input jacks, RIAA equalization, and tone controls.
Describes the pre-driver, inverter, power stage, and protection circuits.
Explains the power supply unit providing DC voltages for the amplifier circuits.
Lists common problems like line consumption, hum, noise, and oscillation.
Step-by-step guide for adjusting amplifier bias and clipping.
Details essential test equipment and their specifications for servicing.
Setup instructions for performance verification tests.
Procedures to measure total hum, noise, and clipping.
Steps to determine maximum power output and harmonic distortion.
Procedures for measuring harmonic distortion at various frequencies.
Procedure to test channel separation performance.
Detailed steps for changing jumper wires to convert voltage.
Details gain, input impedance, frequency response, and distortion levels.
Specifies RMS output power, music power, noise floor, and volume tracking.
Covers dimensions, weight, and power requirements.
To Next Page
